Haemostasis with APC

Non-contact coagulation procedure with superior quality of hemostasis

Haemostasis with APC
Haemostasis with APC Haemostasis with APC
Thermal hemostasis using the ERBE APC 2 is achieved with relatively low energy outputs and thermal heating of the tissue. Argon-Plasma Coagulation (APC) is frequently used to treat chronic, actively bleeding, non-varicose lesions of the gastrointestinal tract. Especially diffuse venous and arterial oozing bleeding can be controlled very well by APC. To treat diffuse bleeding of large surfaces such as occur with ulcerous bleeding, it is necessary to carry out coagulation over a larger surface while limiting the penetration depth. Effective APC modes and various APC probes with diverse beam forms (see detailed fig. 1) generate the necessary tissue effects for a safe hemostasis.

Indications

  • Superficial and small vascular hemorrhages
  • Tumor bleeding
  • Radiation proctitis
  • Vascular malformations, i.e. GAVE syndrome, angiodysplasias, teleangiectasias

Advantages of ERBE equipment

  • Non-contact procedure, no sticking of the instrument tip to the tissue
  • Effective, even surface coagulation, for uniform hemostasis and devitalization
  • Better dosage of penetration depth leads to safer application
  • Limited risk of perforation
  • Minimal carbonization and smoke plume formation, minimal pollution through unpleasant odors
  • Safe procedure with few complications

show additional information
hide additional information

recommended products

APC 2

10134-000

Effective hemostasis and devitalization with Argon-Plasma Coagulation (APC).More...

VIO® 200 D

10140-200

The electrosurgical unit for medical specialities -modular with individual configurations.More...

VIO® 200 S

10140-400

The electrosurgical unit for out-patient specialities.More...

EIP 2 irrigation pump

10325-000

ERBE EIP 2 cleans the operating site, leading to improved visibility and optimization of the surgical effects.More...

ERBE NESSY® OMEGA, split

20193-083

The solution with the ring for All-Round Safety.More...

APC probe 2200

20132-177

More...

Tubing set EIP 2

20325-001

More...

Patient plate cable

20194-077

for patient plates with contact studMore...

APC probe 2200

20132-186

The APC probe (circular) was designed with a radial application angle of 360° for optimal intraluminal applicationMore...

FiAPC Probe 2200

20132-225

with instrument recognition and integrated filterMore...

FiAPC Probe 2200

20132-221

with instrument recognition and integrated filterMore...

Operation steps
Treatment of Radiation Proctitis

Treatment of Radiation Proctitis

Radiation proctitis can take the form of teleangiectasias and hemorrhagic mucosal changes in the area of the rectum (see fig.). The use of APC to treat radiation proctitis is already established; it can lead to an improvement of symptoms and bleeding episodes after an average of two sessions carried out at an interval of three to four weeks.

Angiodysplasia located in the gastric antrum

Angiodysplasia located in the gastric antrum

Usually an application using a low energy output is sufficient to staunch the bleeding. The use of low energy outputs also helps to minimize the risk of perforation in thin-walled areas (e.g. the small intestine or the right colon), where angiodysplasias often occur.

Angiodysplasia located in the colon

Angiodysplasia located in the colon

Angiodysplasia located in the colon before (left) and after treatment with APC (right).

GAVE syndrome

GAVE syndrome

The therapeutic treatment of GAVE syndrome is shown in these figures - GAVE syndrome before (left) and after treatment (right).